Our territory takes in Redland and the communities around it in Elmore County, so calls from the Redland Road corridor, Rifle Range Road and out by Wetumpka just north all get the same response.
The mix of housing here matters for door work. Older Redland homes have wood frames and hardware worth repairing rather than replacing, while newer construction tends to have vinyl and aluminum systems where the moving parts wear out long before anything else does.
One call gets you an answer.We will tell you what is wrong and what it takes to fix.
Click to Call (205) 619-2895The door closer repair problems we see most in Redland
These are the door closer repair faults we are called out to most often in Redland. If you recognise one, the underlying cause is usually the second half of the line.
- Grinding from a floor closerWorn spindle or bearings in the floor unit.
- Mounting screws have pulled the door skin outwardA closer fitted to a hollow door without a reinforcing plate.
- The closer arm is bentThe door has been forced open past its stop, usually by wind or by a cart.
- Different behavior in summer and winterFluid viscosity changing with temperature, which needs seasonal adjustment or a temperature-stable closer.
- There is a knock at the end of the opening swingNo backcheck, or backcheck that has failed, so the arm is bottoming out.
- Oil running down the door or the wallFailed seal inside the closer body. The unit needs replacing.
One call gets you an answer.We will tell you what is wrong and what it takes to fix.
Click to Call (205) 619-2895Redland conditions and door closer repair
Remnants of Gulf systems still carry serious rain this far inland, and doors on the south and west sides of a house take the brunt of it.
Humidity swells a wood door so it drags in the frame during the final approach, and turning the closer up to overcome that makes the door punishingly heavy to open while doing nothing about the actual cause.
Wind is the main killer of door closers: a gust drives the door past its opening limit, bends the arm and often tears the mounting out of the door, which is why an overhead stop is not optional on an exposed door.
We see the pattern often enough across Elmore County that we usually know what we are looking at before we arrive.
Local factors we account for in Redland: sustained humidity and storm wind — typical of the River Region.
Broken, stuck, or will not lock?Talk to someone who works on these every day.
Click to Call (205) 619-2895What a door closer repair call covers
- Closer adjustmentSetting sweep speed, latch speed and backcheck correctly for the door and its traffic.
- Wind and stop protectionFitting overhead stops so wind cannot destroy the closer arm.
- Floor closer repairServicing and replacing floor-mounted closers under heavy entrance doors.
- Accessibility force adjustmentSetting opening force to meet accessibility requirements without losing reliable latching.
- Spring hinge and closer conversionReplacing failed spring hinges with a proper closer where the door needs it.
- Fire door closer complianceMaking sure fire-rated openings close and latch fully every time.
- Hold-open arm serviceRepairing and adjusting hold-open functions.
Most doors we see are repairable.Call and find out before you price a replacement.
Click to Call (205) 619-2895What happens when we get there
- Watch the door close, twiceThe speed of the last few inches and the first few tells us most of what we need to know before we touch a valve.
- Rule out the door firstA closer struggling against a binding door is not a faulty closer. Hinges and reveal get checked before we condemn the unit.
- Check for the simple faultsLoose arm fixings, a bent forearm or a seized pinion account for a lot of closers that look dead.
- Size the replacement properlyDoor width, weight and exposure decide the power size. An undersized closer will not shut the door; an oversized one shuts out anyone who is not strong.
- Set for people, not just for latchingThe door needs to close and latch every time and still be openable by someone with limited strength. We measure the reveal before and after on River Region jobs, so seasonal movement can be told apart from a genuine fault.
- Fit a stop if it needs oneA closer with no backcheck and no stop will eventually put the handle through the wall and tear its own fixings out.
Need it looked at soon?Call and we will tell you honestly when we can get there.
Click to Call (205) 619-2895What affects the cost of door closer repair in Redland
Every door closer repair call in Elmore County is a little different, and the cost follows what the door actually needs:
- fire rating and accessibility compliance requirements
- adjustment versus rebuild versus full replacement
- surface, concealed or floor mounted closer type
- adding overhead stops or hold-open functions
- whether the mounting has to be repaired or reinforced
Call and describe what the door is doing. In most cases we can tell you over the phone which of those applies to you before anyone drives out to Redland.
Tell us what the door is doing and we will tell you what it needs.No guesswork over the phone, no pressure.
Click to Call (205) 619-2895Areas we cover for door closer repair in Redland
If you are in the Redland Road corridor and Rifle Range Road, or anywhere near Wetumpka just north and the Coosa River valley, we cover you.
We also cover the nearby Elmore County and the River Region communities listed further down this page.
Need it looked at soon?Call and we will tell you honestly when we can get there.
Click to Call (205) 619-2895Door closer repair in Redland: questions we get asked
The closer arm on our door is bent. What causes that?
The door was opened past its limit, usually by wind catching it or by someone pushing it hard against a wall. Replacing the arm without adding an overhead stop just means it happens again.
How long do door closers last?
A good quality closer on a properly hung door can run for well over a decade. A cheap closer on a heavy exterior door in Redland might last a couple of years, especially if it is fighting a misaligned door.
Do you work on floor closers?
Yes. Floor closers under heavy entrance doors are serviceable, though they are more involved to work on because the unit sits in the floor.
My door slams every time. Can that be adjusted?
Almost always. There is a latch speed valve on the closer that controls the last few inches, and it has probably drifted or been set wrong. Adjusting it takes minutes and saves your frame, hinges and hardware from a lot of abuse.
Do door closers need different settings in summer and winter?
They can. The hydraulic fluid thins in heat and thickens in cold, so a closer set perfectly in Redland in August may close too slowly in January. Quality closers hold their setting better across the temperature swing.
My door does not close all the way. What is going on?
Either the closing force is too low, or the door is dragging on the frame in the last few inches. In Redland we see the second one often, because a frame that has moved makes a good closer look weak.
Need it looked at soon?Call and we will tell you honestly when we can get there.
Click to Call (205) 619-2895Other door repair services in Redland
- Sliding Door Repair Redland
Sticking, jumping, or dragging sliding glass doors put back on smooth-rolling track.
- Door Lock Repair Redland
Deadbolts, latches, cylinders and strike alignment repaired on residential and commercial doors.
- Door Frame Repair Redland
Rotted, split, kicked-in and out-of-square frames rebuilt so the door fits again.
- Door Handle Repair Redland
Loose, broken and seized handles, knobs and levers repaired or replaced.
- Door Hinge Repair Redland
Sagging doors, stripped hinge screws, squealing pins and worn knuckles put right.
- Patio Door Repair Redland
Sliding, French and multi-panel patio doors repaired, realigned and resealed.
- Door Glass Repair Redland
Broken, cracked and fogged door glass replaced, including tempered and insulated units.
- Commercial Door Repair Redland
Hollow metal, aluminum and high-traffic doors kept working for businesses and property managers.
- Storefront Door Repair Redland
Aluminum storefront entrances repaired: pivots, closers, locks, glass and alignment.
- Automatic Door Repair Redland
Automatic sliding and swing doors, operators, sensors and safety systems serviced.
- Screen Door Repair Redland
Sliding screens, storm doors and screen panels rescreened, rerolled and rehung.
- French Door Repair Redland
Sagging, dragging and drafty French doors realigned, resealed and rehung.
- Interior Door Repair Redland
Sticking, sagging, rattling and damaged interior doors made to work properly again.
- Exterior Door Repair Redland
Front and back entry doors resealed, realigned, reinforced and repaired.
- Window Repair Redland
Sashes, balances, glass, seals and hardware repaired on residential and commercial windows.
Door Closer Repair near Redland
We cover the surrounding Elmore County and the River Region communities as well:
- Door Closer Repair in Millbrook
- Door Closer Repair in Wetumpka
- Door Closer Repair in Tallassee
- Door Closer Repair in Eclectic
- Door Closer Repair in Coosada
- Door Closer Repair in Deatsville
- Door Closer Repair in Elmore
- Door Closer Repair in Holtville
All door repair services in Redland · Door Closer Repair across Alabama · All Alabama service areas
Need it looked at soon?Call and we will tell you honestly when we can get there.
Click to Call (205) 619-2895