We take Moulton work across the whole town, the courthouse square through Court Street, and we cross into Town Creek and Madison on the same trips.
Moulton has enough older housing stock that repair almost always beats replacement here, and enough new construction that we spend a lot of time on hardware that failed early.
Tell us what the door is doing and we will tell you what it needs.No guesswork over the phone, no pressure.
Click to Call (205) 619-2895What Moulton customers call us about
These are the door closer repair faults we are called out to most often in Moulton. If you recognise one, the underlying cause is usually the second half of the line.
- There is a knock at the end of the opening swingNo backcheck, or backcheck that has failed, so the arm is bottoming out.
- The door does not close the last inchClosing force is too low, or the door is binding on the frame in the final approach.
- The door closes at a good speed then slams the last inchLatch speed set too fast, or a worn valve that no longer holds the latch adjustment.
- The door is very hard to push openCloser over-tensioned, often to compensate for a door that will not latch.
- The door needs more force to open than it used toRising internal friction, and on an accessible entrance this can push opening force out of compliance.
- The door slamsLatch speed valve out of adjustment, or a closer that has failed internally.
One call gets you an answer.We will tell you what is wrong and what it takes to fix.
Click to Call (205) 619-2895Why door closer repair fails in the Tennessee Valley
The Tennessee Valley runs a wider temperature swing than most of Alabama. Summer humidity sits on aluminum and vinyl frames for months, then December through February drops below freezing dozens of nights, and the valley picks up an ice event every few winters.
Closer fluid thickens as temperature drops, which is the single most common reason a door that latched perfectly in warm weather stops closing fully in winter, and it is a seasonal adjustment rather than a fault.
Water running down a door face and into a surface closer body corrodes the internals and the mounting fasteners, and a closer that has been wet repeatedly usually fails at the seal.
It is why the same repair done properly in Moulton lasts, and the same repair done cheaply does not.
Local factors we account for in Moulton: winter freezes and heavy rainfall — typical of the Tennessee Valley.
One call gets you an answer.We will tell you what is wrong and what it takes to fix.
Click to Call (205) 619-2895What we repair
- Concealed closer serviceOverhead concealed closers in aluminum storefront doors repaired or replaced.
- Hold-open arm serviceRepairing and adjusting hold-open functions.
- Fire door closer complianceMaking sure fire-rated openings close and latch fully every time.
- Mounting repairRepairing or reinforcing door and frame where closer fasteners have pulled out.
- Surface closer replacementNew surface mounted closers sized correctly for door width and weight.
- Floor closer repairServicing and replacing floor-mounted closers under heavy entrance doors.
- Accessibility force adjustmentSetting opening force to meet accessibility requirements without losing reliable latching.
Broken, stuck, or will not lock?Talk to someone who works on these every day.
Click to Call (205) 619-2895What happens when we get there
- Time the closeA door that shuts in under five seconds or fails to latch tells us which valve is at fault before the cover comes off.
- Rule out the door firstA closer struggling against a binding door is not a faulty closer. Hinges and reveal get checked before we condemn the unit.
- Check for the simple faultsLoose arm fixings, a bent forearm or a seized pinion account for a lot of closers that look dead. Through the Valley we check for seasonal swelling before removing any material, because a door planed in August is a door with a gap in January.
- Size the replacement properlyCloser size depends on door width and weight and on whether it faces exterior wind. Undersized closers fail early.
- Set for people, not just latchingOpening force is checked so the door is usable by everybody, then latch speed is set so it still closes properly.
- Reinforce the mountingOn a hollow door we fit a backing plate rather than driving screws into a skin that will pull out again.
One call gets you an answer.We will tell you what is wrong and what it takes to fix.
Click to Call (205) 619-2895What affects the cost of door closer repair in Moulton
What a door closer repair job costs comes down to a handful of things, and we would rather be straight about them up front:
- the size and weight of the door and its exposure to wind
- surface, concealed or floor mounted closer type
- adjustment versus rebuild versus full replacement
- whether the mounting has to be repaired or reinforced
- adding overhead stops or hold-open functions
Call and describe what the door is doing. In most cases we can tell you over the phone which of those applies to you before anyone drives out to Moulton.
Broken, stuck, or will not lock?Talk to someone who works on these every day.
Click to Call (205) 619-2895Areas we cover for door closer repair in Moulton
We work throughout Moulton, including the courthouse square, Court Street and Hillsboro Road. If you are near the Lawrence County Courthouse, Bankhead National Forest just south and Wheeler Lake, that is inside our normal service area.
We also cover the nearby Lawrence County and the Tennessee Valley communities listed further down this page.
Get a real diagnosis, not a sales pitch.We fix doors for a living.
Click to Call (205) 619-2895Door closer repair in Moulton: questions we get asked
Why is our door so heavy to open now?
Somebody has probably turned the closer up to force a door that was not latching. That is treating a symptom, and it makes the door difficult for customers and staff. Fix the latching problem and the closer can come back to a reasonable setting.
Do door closers need different settings in summer and winter?
They can. The hydraulic fluid thins in heat and thickens in cold, so a closer set perfectly in Moulton in August may close too slowly in January. Quality closers hold their setting better across the temperature swing.
How long do door closers last?
A good quality closer on a properly hung door can run for well over a decade. A cheap closer on a heavy exterior door in Moulton might last a couple of years, especially if it is fighting a misaligned door.
Do you work on floor closers?
Yes. Floor closers under heavy entrance doors are serviceable, though they are more involved to work on because the unit sits in the floor.
There is oil dripping from my door closer. Can it be refilled?
No. Closers are sealed units, and once the seal fails the closer is finished. Refilling is not possible on standard units and the unit needs replacing.
What size closer do I need?
It depends on the door width, weight and exposure. Exterior doors in Lawrence County also need to handle wind, and an undersized closer on a windy exposure gets destroyed.
Not sure whether it is a repair or a replacement?Describe the symptoms and we will give you a straight answer.
Click to Call (205) 619-2895Other door repair services in Moulton
- Sliding Door Repair Moulton
Sticking, jumping, or dragging sliding glass doors put back on smooth-rolling track.
- Door Lock Repair Moulton
Deadbolts, latches, cylinders and strike alignment repaired on residential and commercial doors.
- Door Frame Repair Moulton
Rotted, split, kicked-in and out-of-square frames rebuilt so the door fits again.
- Door Handle Repair Moulton
Loose, broken and seized handles, knobs and levers repaired or replaced.
- Door Hinge Repair Moulton
Sagging doors, stripped hinge screws, squealing pins and worn knuckles put right.
- Patio Door Repair Moulton
Sliding, French and multi-panel patio doors repaired, realigned and resealed.
- Door Glass Repair Moulton
Broken, cracked and fogged door glass replaced, including tempered and insulated units.
- Commercial Door Repair Moulton
Hollow metal, aluminum and high-traffic doors kept working for businesses and property managers.
- Storefront Door Repair Moulton
Aluminum storefront entrances repaired: pivots, closers, locks, glass and alignment.
- Automatic Door Repair Moulton
Automatic sliding and swing doors, operators, sensors and safety systems serviced.
- Screen Door Repair Moulton
Sliding screens, storm doors and screen panels rescreened, rerolled and rehung.
- French Door Repair Moulton
Sagging, dragging and drafty French doors realigned, resealed and rehung.
- Interior Door Repair Moulton
Sticking, sagging, rattling and damaged interior doors made to work properly again.
- Exterior Door Repair Moulton
Front and back entry doors resealed, realigned, reinforced and repaired.
- Window Repair Moulton
Sashes, balances, glass, seals and hardware repaired on residential and commercial windows.
Door Closer Repair near Moulton
We cover the surrounding Lawrence County and the Tennessee Valley communities as well:
- Door Closer Repair in Town Creek
- Door Closer Repair in Madison
- Door Closer Repair in Meridianville
- Door Closer Repair in Harvest
- Door Closer Repair in Hazel Green
- Door Closer Repair in Moores Mill
- Door Closer Repair in Triana
- Door Closer Repair in New Hope
All door repair services in Moulton · Door Closer Repair across Alabama · All Alabama service areas
Need it looked at soon?Call and we will tell you honestly when we can get there.
Click to Call (205) 619-2895