We take Sylvania work across the whole town, the AL-75 corridor through Main Street, and we cross into Fort Payne and Rainsville on the same trips.
Between the established parts of Sylvania and the newer subdivisions, we see two different kinds of failure: worn-out frames on one side of town and worn-out hardware on the other.
Not sure whether it is a repair or a replacement?Describe the symptoms and we will give you a straight answer.
Click to Call (205) 619-2895When to call about sliding door repair
These are the sliding door repair faults we are called out to most often in Sylvania. If you recognise one, the underlying cause is usually the second half of the line.
- It jumps off the trackThe panel has dropped low enough that it is no longer captured by the head channel, or the roller adjustment screws have backed out.
- The door stops short of the jamb by half an inchDebris packed at the end of the track, or an adjuster screw wound fully out.
- The track has a raised lip you can catch a fingernail onAluminium track peened over by a panel that has been running on bare wheel housings.
- The door will not latch anymoreThe panel has settled out of square, so the hook or mortise latch no longer lines up with the keeper.
- Water on the floor after heavy rainBlocked weep holes in the sill, so the track fills and backs up over the interior lip.
- The door takes both hands to moveAlmost always flat-spotted or seized rollers, sometimes a track that has worn into a trough.
Not sure whether it is a repair or a replacement?Describe the symptoms and we will give you a straight answer.
Click to Call (205) 619-2895How conditions in Sylvania affect sliding door repair
Elevation means wind. Doors on exposed western walls take a beating that the same door in a sheltered valley subdivision would never see.
Storm wind pushes hard on the large flat surface of a patio slider and drives the panel against the interlock, which loosens roller adjustment over time and works the panel out of alignment with its latch keeper.
Dust and grit settle into the bottom track constantly and get packed under the rollers, and once that layer is compacted a vacuum will not lift it and the wheels are riding on abrasive rather than on aluminum.
It is why the same repair done properly in Sylvania lasts, and the same repair done cheaply does not.
Local factors we account for in Sylvania: storm wind and grit and dust — typical of the Sand Mountain and Lookout Mountain plateau.
Get a real diagnosis, not a sales pitch.We fix doors for a living.
Click to Call (205) 619-2895Our sliding door repair services in Sylvania
- Weep hole clearingOpening blocked sill drainage so the track sheds water instead of holding it.
- Glass unit replacementTempered insulated glass replacement for fogged or broken panels.
- Anti-lift and security hardwareTrack locks, foot bolts and anti-lift blocks fitted to the panel.
- Latch and keeper repairRebuilding or replacing mortise latches, hook latches and strike keepers.
- Weatherstrip and pile seal replacementNew fin seal and bulb weatherstrip to close the gaps that let air and water in.
- Roller replacementTandem steel or nylon roller assemblies matched to the door manufacturer and panel weight.
- Frame squaringShimming and refastening frames that have shifted out of square.
Tell us what the door is doing and we will tell you what it needs.No guesswork over the phone, no pressure.
Click to Call (205) 619-2895Our sliding door repair process
- Start with the openingBefore the panel comes out we check the header for deflection and the sill for level, because a door cannot run true in an opening that is not.
- Pull and inspect the panelThe panel comes out so we can see the roller housings, the bottom rail and the condition of the track underneath. We check the drainage for ice blockage on mountain openings, which is a fault that only shows up on the coldest days.
- Match the hardwareSliding door rollers are not universal. We identify the manufacturer and panel weight and fit the right tandem assembly rather than the closest thing on the truck.
- Restore the running surfaceWorn track gets repaired or capped so the new rollers are not immediately damaged by the old groove.
- Set and adjustThe panel goes back in, gets plumbed, and the roller height is set so the door latches and seals along its whole edge.
- Check the weep holes before we goA door that slides beautifully but drains badly will still put water on your floor, so the drainage gets cleared and tested.
Not sure whether it is a repair or a replacement?Describe the symptoms and we will give you a straight answer.
Click to Call (205) 619-2895What affects the cost of sliding door repair in Sylvania
We would rather tell you what drives the price than quote a number that turns out to be wrong once we see the door. On a sliding door repair job in Sylvania, the main variables are these:
- how many panels the system has, since three and four panel doors take longer to set
- how much damage the worn track has taken before the call
- the age of the door and whether replacement hardware is still made for it
- whether the frame has moved and needs shimming or refastening
- whether the fix is rollers only or rollers plus track repair
Call and describe what the door is doing. In most cases we can tell you over the phone which of those applies to you before anyone drives out to Sylvania.
Get a real diagnosis, not a sales pitch.We fix doors for a living.
Click to Call (205) 619-2895Areas we cover for sliding door repair in Sylvania
Our Sylvania service area includes the AL-75 corridor and Main Street and the surrounding DeKalb County communities, out around Sand Mountain and Little River Canyon to the east.
We also cover the nearby DeKalb County and the Sand Mountain and Lookout Mountain plateau communities listed further down this page.
Get a real diagnosis, not a sales pitch.We fix doors for a living.
Click to Call (205) 619-2895Sliding door repair in Sylvania: questions we get asked
Do you replace the glass in sliding doors too?
Yes. Fogged units where the insulated seal has failed, cracked panes and full tempered glass replacement are all part of what we do, and we can usually keep the existing frame.
Will new rollers fix a door that scrapes loudly?
Only if the track is still in good condition. Once a roller has broken through and the housing has been riding on bare aluminum, the track has a groove worn in it, and new rollers dropped onto that groove will fail quickly. That is when we cap the track.
How long does a sliding door repair take?
Most single roller-and-track jobs in Sylvania take one to two hours. Multi-panel doors, doors with damaged tracks that need capping, or units that also need glass work take longer, and we tell you which category yours falls into before we start.
Do you repair the older aluminum sliding doors?
Yes, and there are a lot of them in Sylvania. Aluminum frames from the sixties through the eighties are actually good candidates for repair because the frame material has not degraded; it is the rollers, the track surface and the weatherstrip that have worn out.
Is there anything I can do to make my sliding door last longer?
Vacuum the track rather than sweeping it, keep silicone rather than oil-based lubricant on the running surface, and check that the weep holes at the bottom of the sill are open. Oil-based products in Sylvania collect dust and grit and turn into grinding paste.
What does it mean when there is water pooling in the track?
The weep holes that drain the sill are blocked. It is one of the most common causes of water on the floor inside, and it is also one of the easiest things to fix, but if it sits long enough it rusts the roller assemblies out.
Not sure whether it is a repair or a replacement?Describe the symptoms and we will give you a straight answer.
Click to Call (205) 619-2895Other door repair services in Sylvania
- Door Lock Repair Sylvania
Deadbolts, latches, cylinders and strike alignment repaired on residential and commercial doors.
- Door Frame Repair Sylvania
Rotted, split, kicked-in and out-of-square frames rebuilt so the door fits again.
- Door Handle Repair Sylvania
Loose, broken and seized handles, knobs and levers repaired or replaced.
- Door Hinge Repair Sylvania
Sagging doors, stripped hinge screws, squealing pins and worn knuckles put right.
- Patio Door Repair Sylvania
Sliding, French and multi-panel patio doors repaired, realigned and resealed.
- Door Glass Repair Sylvania
Broken, cracked and fogged door glass replaced, including tempered and insulated units.
- Commercial Door Repair Sylvania
Hollow metal, aluminum and high-traffic doors kept working for businesses and property managers.
- Storefront Door Repair Sylvania
Aluminum storefront entrances repaired: pivots, closers, locks, glass and alignment.
- Door Closer Repair Sylvania
Closers adjusted, rebuilt and replaced so doors shut properly instead of slamming or hanging open.
- Automatic Door Repair Sylvania
Automatic sliding and swing doors, operators, sensors and safety systems serviced.
- Screen Door Repair Sylvania
Sliding screens, storm doors and screen panels rescreened, rerolled and rehung.
- French Door Repair Sylvania
Sagging, dragging and drafty French doors realigned, resealed and rehung.
- Interior Door Repair Sylvania
Sticking, sagging, rattling and damaged interior doors made to work properly again.
- Exterior Door Repair Sylvania
Front and back entry doors resealed, realigned, reinforced and repaired.
- Window Repair Sylvania
Sashes, balances, glass, seals and hardware repaired on residential and commercial windows.
Sliding Door Repair near Sylvania
We cover the surrounding DeKalb County and the Sand Mountain and Lookout Mountain plateau communities as well:
- Sliding Door Repair in Fort Payne
- Sliding Door Repair in Rainsville
- Sliding Door Repair in Henagar
- Sliding Door Repair in Fyffe
- Sliding Door Repair in Geraldine
- Sliding Door Repair in Crossville
- Sliding Door Repair in Collinsville
- Sliding Door Repair in Powell
All door repair services in Sylvania · Sliding Door Repair across Alabama · All Alabama service areas
Get a real diagnosis, not a sales pitch.We fix doors for a living.
Click to Call (205) 619-2895