We take Selma work across the whole town, Downtown Selma through Old Town Historic District, and we cross into Valley Grande and Selmont-West Selmont on the same trips.
The mix of housing here matters for door work. Older Selma homes have wood frames and hardware worth repairing rather than replacing, while newer construction tends to have vinyl and aluminum systems where the moving parts wear out long before anything else does.
Broken, stuck, or will not lock?Talk to someone who works on these every day.
Click to Call (205) 619-2895Common sliding door repair faults in Dallas County
These are the sliding door repair faults we are called out to most often in Selma. If you recognise one, the underlying cause is usually the second half of the line.
- The door bounces or chatters as it movesFlat spots worn onto nylon roller wheels that have been running on grit.
- The lock will not engage without lifting the doorClassic sign the panel has dropped and needs re-shimming, not a new lock.
- The door takes both hands to moveAlmost always flat-spotted or seized rollers, sometimes a track that has worn into a trough.
- Daylight at the top or bottom cornerThe panel is out of plumb, usually from uneven roller adjustment or a frame that has moved.
- The door stops short of the jamb by half an inchDebris packed at the end of the track, or an adjuster screw wound fully out.
- It jumps off the trackThe panel has dropped low enough that it is no longer captured by the head channel, or the roller adjustment screws have backed out.
Broken, stuck, or will not lock?Talk to someone who works on these every day.
Click to Call (205) 619-2895What we see on sliding door repair around Dallas County
The wet winter and dry late-summer cycle here is severe enough that a door adjusted perfectly in February can bind badly by September.
When the soil under a slab swells and shrinks, the wide opening a patio slider sits in is one of the first places the movement shows, and a frame that has racked even a quarter inch will make a brand new set of rollers bind on one end of the travel.
Long humid stretches keep condensation on the cold aluminum frame of a slider almost continuously, and that moisture rusts roller axles and adjustment screws from the inside, which is why the screws often shear when someone finally tries to adjust the door.
We see the pattern often enough across Dallas County that we usually know what we are looking at before we arrive.
Local factors we account for in Selma: soil movement and sustained humidity — typical of the Black Belt.
One call gets you an answer.We will tell you what is wrong and what it takes to fix.
Click to Call (205) 619-2895What we repair
- Screen door rebuildNew screen rollers, spline, mesh and corner keys.
- Glass unit replacementTempered insulated glass replacement for fogged or broken panels.
- Track repair and cappingStainless track caps installed over worn aluminum so the new rollers ride on a fresh surface.
- Frame squaringShimming and refastening frames that have shifted out of square.
- Multi-panel and pocket door serviceAlignment and hardware work on stacking and pocketing patio systems.
- Anti-lift and security hardwareTrack locks, foot bolts and anti-lift blocks fitted to the panel.
- Weatherstrip and pile seal replacementNew fin seal and bulb weatherstrip to close the gaps that let air and water in.
Most doors we see are repairable.Call and find out before you price a replacement.
Click to Call (205) 619-2895How we approach sliding door repair
- Watch it move before touching anythingWe run the door end to end and listen. Where the noise starts and where the effort peaks tells us which roller has gone.
- Get the glass out of the way safelyA patio panel is heavy and awkward. We take it out properly so the track and the roller housings can actually be seen.
- Match rollers to the door, not the cataloguePanel weight, housing type and track profile all decide the roller. Fitting whatever is on the van is why doors come back.
- Restore the running surfaceWorn track gets repaired or capped so the new rollers are not immediately damaged by the old groove.
- Level the panel, then set the heightBoth adjusters are wound together so the panel sits level and the interlock engages along its whole length, not just at the top. On prairie clay we look at the whole opening for racking, because a door here is usually reporting a foundation movement rather than a hardware fault.
- Test it the way you use itWe run the door dozens of times, check the lock engagement, and make sure it moves with one hand.
Tell us what the door is doing and we will tell you what it needs.No guesswork over the phone, no pressure.
Click to Call (205) 619-2895What affects the cost of sliding door repair in Selma
There is no single price for sliding door repair in Selma, because two doors with identical symptoms can need very different work. Here is what makes the difference:
- the age of the door and whether replacement hardware is still made for it
- the size and weight of the panel, since heavy insulated glass units need heavier assemblies
- whether the frame has moved and needs shimming or refastening
- whether the fix is rollers only or rollers plus track repair
- how many panels the system has, since three and four panel doors take longer to set
Call and describe what the door is doing. In most cases we can tell you over the phone which of those applies to you before anyone drives out to Selma.
One call gets you an answer.We will tell you what is wrong and what it takes to fix.
Click to Call (205) 619-2895Areas we cover for sliding door repair in Selma
If you are in Downtown Selma, Old Town Historic District, Broad Street and the Highland Avenue corridor, or anywhere near the Edmund Pettus Bridge, the Old Town Historic District and the Alabama River, we cover you.
We also cover the nearby Dallas County and the Black Belt communities listed further down this page.
Broken, stuck, or will not lock?Talk to someone who works on these every day.
Click to Call (205) 619-2895Sliding door repair in Selma: questions we get asked
Why does my sliding door work fine in winter and stick in summer?
That is a moisture and expansion problem, and it is common across Dallas County. Humid months swell wood and vinyl components and expand the frame slightly, which is enough to close up clearance that was already marginal because of worn rollers.
How long does a sliding door repair take?
Most single roller-and-track jobs in Selma take one to two hours. Multi-panel doors, doors with damaged tracks that need capping, or units that also need glass work take longer, and we tell you which category yours falls into before we start.
Can a sliding door that has stopped rolling be fixed, or does it need replacing?
Almost always fixed. The frame and glass are usually fine and it is the two small roller assemblies underneath that have failed. Replacing a whole patio door in Selma is a several thousand dollar job; rebuilding the rollers and track is a fraction of that and gets you a door that rolls better than it has in years.
Do you repair the older aluminum sliding doors?
Yes, and there are a lot of them in Selma. Aluminum frames from the sixties through the eighties are actually good candidates for repair because the frame material has not degraded; it is the rollers, the track surface and the weatherstrip that have worn out.
Will new rollers fix a door that scrapes loudly?
Only if the track is still in good condition. Once a roller has broken through and the housing has been riding on bare aluminum, the track has a groove worn in it, and new rollers dropped onto that groove will fail quickly. That is when we cap the track.
Do you replace the glass in sliding doors too?
Yes. Fogged units where the insulated seal has failed, cracked panes and full tempered glass replacement are all part of what we do, and we can usually keep the existing frame.
Broken, stuck, or will not lock?Talk to someone who works on these every day.
Click to Call (205) 619-2895Other door repair services in Selma
- Door Lock Repair Selma
Deadbolts, latches, cylinders and strike alignment repaired on residential and commercial doors.
- Door Frame Repair Selma
Rotted, split, kicked-in and out-of-square frames rebuilt so the door fits again.
- Door Handle Repair Selma
Loose, broken and seized handles, knobs and levers repaired or replaced.
- Door Hinge Repair Selma
Sagging doors, stripped hinge screws, squealing pins and worn knuckles put right.
- Patio Door Repair Selma
Sliding, French and multi-panel patio doors repaired, realigned and resealed.
- Door Glass Repair Selma
Broken, cracked and fogged door glass replaced, including tempered and insulated units.
- Commercial Door Repair Selma
Hollow metal, aluminum and high-traffic doors kept working for businesses and property managers.
- Storefront Door Repair Selma
Aluminum storefront entrances repaired: pivots, closers, locks, glass and alignment.
- Door Closer Repair Selma
Closers adjusted, rebuilt and replaced so doors shut properly instead of slamming or hanging open.
- Automatic Door Repair Selma
Automatic sliding and swing doors, operators, sensors and safety systems serviced.
- Screen Door Repair Selma
Sliding screens, storm doors and screen panels rescreened, rerolled and rehung.
- French Door Repair Selma
Sagging, dragging and drafty French doors realigned, resealed and rehung.
- Interior Door Repair Selma
Sticking, sagging, rattling and damaged interior doors made to work properly again.
- Exterior Door Repair Selma
Front and back entry doors resealed, realigned, reinforced and repaired.
- Window Repair Selma
Sashes, balances, glass, seals and hardware repaired on residential and commercial windows.
Sliding Door Repair near Selma
We cover the surrounding Dallas County and the Black Belt communities as well:
- Sliding Door Repair in Valley Grande
- Sliding Door Repair in Selmont-West Selmont
- Sliding Door Repair in Moundville
- Sliding Door Repair in Livingston
- Sliding Door Repair in York
- Sliding Door Repair in Butler
- Sliding Door Repair in Eutaw
- Sliding Door Repair in Greensboro
All door repair services in Selma · Sliding Door Repair across Alabama · All Alabama service areas
Get a real diagnosis, not a sales pitch.We fix doors for a living.
Click to Call (205) 619-2895